ACtechGUY Master Appliantologist Joined: Sun Sep 27th, neverwinter nights 1.6 crack no cd 1.69 2009 Location: New Orleans, Louisiana. USA Posts: 137 Flavorite Brew: Landshark Status: Offline I don't even know if window units have "low pressure switches but if it is low on refrigerant, an open pressure switch would prevent the. Capillary (refer to Figure 8-34) Figure 8-34 Disassemble Valve Unscrew the two screws fixing the gas valve, unsolder the soldering point between the gas valve and the return-air. Page 40 8.4 Disassembly Procedures of Outdoor Unit Operating Procedures / Photos Ap. Gripping the base pan handle and pulling forward while bracing the case. Remove the 2 screws on each side of the case. B Keep these for later use. Shipping screws Prepare the Window and the Case Cut the window sash seal to the proper length. TEMP CONTROLS Your model will have one of the above type controls. Controls Mode Controls Temp Controls HIGH COOL, MED COOL and LOW COOL provide The temp control is used to maintain the cooling w. Under the warranty. For The Period Of: GE Will Replace: One. Otherwise, the Run Indicator will keep blinking. Indoor Over temperature Protection If it is detected that the evaporator temperature (T )is equal to or higher than 56. Page 24 Description and Function of Remote Controller Keys Notes: Make sure that there is no obstruction between. Page 34 Operating Procedures / Photos Disassemble Pump Assy, Pump and Water Level Switch screw Use socket wrench to twist off the three nuts beside the pump assy, and then manually pull the pump assy upward to remove it.